Publicidad
Idiomas disponibles
Idiomas disponibles
2. MOUNTING THE SANDING PAD
Follow the steps to remove the disc prescribed above
(step 1).
First position the sand paper (21) over the sanding
pad (20)then insert countersunk screw (23) into the
clamping bush (22) and together insert them into the
sanding pad centre hole. Next insert the sanding pad
over the small pulley (11) (Fig. F) and tighten the screw
onto the mini shaft.
3. MOUNTING THE DUST EXTRACTION
To fit-on the dust extraction, first insert the front lugs
of the Dust Extraction Cover (19) under the Guard
Cover cut-outs, then push down the rear end to snap
the latches over the Extension Arm side lugs as shown
in Fig.G. Fit the vacuum cleaner hose into the Dust
extraction hole (Fig. H). Dust extraction fits hose size
Ø35mm.
To remove the Dust Extraction Cover pull the dust
extraction latch sideway from the extension arm and
then pull out in reverse direction.
WARNING:
•
To reduce the risk of personal injury always use
dust extraction.
•
Provide for sufficient dust extraction when cutting
masonry materials.
•
The vacuum cleaner must be approved for
vacuuming masonry dust
•
Wear a dust respirator .
•
The machine may be used only for dry cutting/
grinding.
WARNING: ALWAYS WEAR
CORRECT SAFETY CLOTHING,
INCLUDING EAR, EYE AND LUNG
PROTECTION.
DO NOT use under the wet conditions or in presence
of flammable liquids and gasses.
CAUTION: Use correct personal protection equipment
when working on materials treated or containing
toxic substances and follow local government safety
regulations.
OPERATION
Always use two hands to operate the Mini Carver,
placing the left hand on the auxiliary handle and the
right on the tool body ( Fig. J)
Ensure the machine is running BEFORE contacting
the material, to be worked on. To sand, grind or
woodcarving, hold the Mini Carver as shown in Fig. K
5
English
CUTTING GRIP
Use the Mini Industrial Blade to cut or remove wood
and plastics.
Use the Mini Sanding Pads for cleaning and sanding
wood, plastics, metal, paint and much more.
Use the diamond blade for cutting and recessing any
masonry based material.
STARTING OPERATION
Observe correct mains voltage! The voltage of the
power source must agree with the voltage specified
on the nameplate of the machine. Power tools marked
with 230-240V can also be operated with 220 V.
SHOWING ANGLE & DIRECTION OF
CUT
25-30° is a comfortable working angle.
Use the bottom edge of the blade (as shown in Fig.L /
M) and not as in Fig.N.
SWITCHING ON AND OFF
To start the power tool, push the On/Off switch 3
forwards.
To lock the On/Off switch 3, press the On/Off switch 3
down at the front until it latches.
To switch off the power tool, release the On/Off switch
3, or if it is locked, briefly push down the back of the
On/Off switch 3 and then release it.
-
Check grinding tools before using. The grinding
tool must be mounted properly and be able to
move freely.
Test run the grinder with no load prior use. Do not use
damaged, out-of-centre or vibrating tools.
CAUTION:
Restarting protection – The restarting protection
feature prevents uncontrolled restarting of the
machine after an interruption in the power supply.
To restart the operation, switch the On/Off switch 3
to the off position and start the machine again.
WARNING:
-
Always read the safety instructions and
applicable regulations
-
Support and secure the work piece to prevent
movement and loss of control.
-
Do not exert pressure or strain the machine so
heavily that it comes to a standstill.
Publicidad
