Publicidad
Idiomas disponibles
Idiomas disponibles
The cabinet body has a snug fit to the cabinet
top, you may need a flat head screwdriver to
guide one side of the top into place from the
inside of the cabinet or use a rubber mallet
to gently tap from the inside so that the top
sits flat on the cabinet body. Remove any
remaining protective film from the top. Do not
use a knife or sharp object to remove the film.
If you start at a side edge and pull slowly, the
protective film will release from the top.
To secure the top, (you will need to do this
from the inside of the cabinet), bolt the top
flanges that are inside the cabinet body, to the
body of the cabinet. With 10 bolts (B), 2 on
each side and 3 on the front and the back that
screw upwards into the top. Finger tighten the
bolts in place. Then tighten all the bolts using
either the hex key or the bit and extender that
are included in the Hardware Bag. Using your
drill, may make some of these fasteners easier
to install. Be sure not to over tighten.
DETAIL AND
FINISHING
With the cabinet assembled and in place,
check to make sure it is still level. Adjust the
leveling feet if needed. This is a two person
job, one to tip the cabinet back slightly and
the other to adjust the leveling feet.
Continue to assemble your cabinet per
cabinet instructions.
6 | www.bluesk youtdoorliving.com
Publicidad
