Descargar Imprimir esta página

DeWalt DXPAEV032 Manual De Instrucciones página 5

Cargador portátil de vehículo eléctrico de 32 a

Publicidad

Idiomas disponibles

Idiomas disponibles

SAVE THESE
INSTRUCTIONS
Before First Use
DANGER: Risk of suffocation! Keep any packaging materials
away from children and pets - these materials are a potential
source of danger, e.g. suffocation.
Remove all packaging materials
Remove and review all components before use.
Check the product for transport damages.
Main Unit Components
A. Main Unit
B. Display
C. Charging Handle
D. Release Lever
F
G
C
E
F
Display
H. Output Current
I. Charging Status
J. Voltage
K. Actual Current
H
32 AMP
CHARGING
240.0V
32.0A
10.5KWH
2H 10M
CHARGE TIME
E. Protective Cover
F. NEMA 14-50 Adapter
G. NEMA 5-15 Adapter
D
A
B
L . Electricity Consumption
M. Charging Time
I
J
K
L
M
M
Installation Instructions
CAUTION: Protect the product from harsh weather conditions
such as rain, snow and extreme temperatures. Consider installing the
product under a carport or in a garage.
CAUTION: Install the product in a safe location away from
flammable materials and out of reach of children and pets.
NOTICE: It is recommended to install the product at a sufficient
height from grade such that the height of the storage means for the
coupling device is located between 24" (600 mm) and 48" (1.
from grade.
Install the product within convenient proximity to where there is
an existing outlet. Additionally, ensure that the cord or wiring
leading into the product has some slack.
For optimal charging efficiency, place the product as close as
possible to the electrical panel to avoid lengthy cable runs.
Install the product to an easily accessible location for the driver
to plug in and out the vehicle. Make sure the installation location
allows enough slack for the charging cable to reach the vehicle's
charging port.
The wall used for installation must have the capacity to support
the weight of the product and its accessories and must remain
level once the installation is completed.
Avoid installing the product in areas with excessive vibration or
elevated temperatures.
To attach an adapter, line up the adapter with the controller of the
Main unit and push it into the socket until it snaps into place.
Note: The Mobile Connector automatically detects the attached
adapter and sets the appropriate current draw.
Plug-in Installation
CAUTION:
Always inspect the main unit and adapter for damage
prior to each use.
CAUTION: Ensure that the proper dedicated outlet is available for
use with this product.
Alternatively, a licensed electrician may install a NEMA outlet.
CAUTION:
The NEMA outlet should be located 20-26 in
(500-660 mm) from the ground adjacent to the stud where the
product is to be mounted.
CAUTION: Unplug the product before making any changes.
Step 1: Make sure the holes are aligned
Small Hole
Step 2: Push the adapter into the control box
Step 3: Rotate the locking ring tightly
NEMA 14-50
Same connection method for NEMA 5-15
NEMA 5-15
To remove the adapter, loose the locking ring, pull out the adapter
from the control box.
1. Ensure the adapter matches the outlet you want to use.
2. Plug the adapter into the power outlet. The adapter should be
inserted completely into the power outlet
5
Small Pin

Publicidad

loading