NOTE:It maybenecessary t o movethe handle
supports f romsideto sideinordertoalignthe handle
so itwill slideoverthe handle supports.
4. Insert"L"boltthrough holeon rightsideof handle
(viewing fromhandle sideof unit)andattach
plastic knob.Tighten knobby hand.
5. Insertcarriage boltthrough leftsideholefrom
outside of unitandattacha plastic knobfrom
insideof unit(viewing unitfromthehandle side).
Tighten by hand.
6. Insert
"J+'hook into second from left slot in
accessory tray.
7.
Pinch chemical hose and slide it into metal clip as
shown.
.
Tilt unit up by handle and attach metal clip to rib
on center underside of accessory tray. Slide
chemical hose through metal clip so that it is tight
but not kinked.
Add
Engine
Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SG, SH, SJ or higher rated SAE 30
weight. DO NOT use special additives.
1.
Choose a viscosity according to table below.
p
_20
_
_0
32
4o
_0
_0
lOO
0
1
,
,
,
C
+_
+2
tJ
t_
lg
2g
3g
_g
STARTING
TEMPERATURE
RANGE
ANTICTPATED
BEFORE
NEXT
OIL CNANGE
* The use of multi-viscosity
oils (5W-30,
10W-30, etc.)
in temperatures above 40°F (4_C) will result in higher
than normal oil consumption.
When using a multi-
viscosity oil, check oil more frequently.
** If using SAE 30 oil in temperatures below 40_F
(4_C), it will result in hard starting and possible
engine bore damage due to inadequate lubrication.
2.
Place pressure washer on a level surface.
3.
Clean area around oil fill.
4.
Remove oil fill cap.
5.
Pour oil slowly. Fill to the point of overflowing.
6.
Replace oil fill cap, tighten securely.
NOTE: Check oil often during engine break-in.
Add Fuel
,_
WARNINGf
NEVER fill fuel tank indoors.
NEVER fill fuel tank when engine is running or
hot. Allow unit to cool for two minutes before
refueling. DO NOT light a cigarette or smoke
when filling the fuel tank.
,_
WARNING]
NEVER fill fuel tank completely
full. Provide space for fuel expansion. Wipe
away any fuel spillage from engine and
equipment before starting.
Use fresh, clean unleaded automotive fuel and
store in approved, clean, covered containers. Use
clean fill funnels. NEVER use "stale" fuel left over
from last season or fuel stored for long periods.
Clean area around fuel fill cap, remove cap.
7