Code 3 C5590 Serie Instrucciones De Instalación Y Operación

IMPORTANT! Read all instructions before installing and using. Installer: This manual must be delivered to the end user.
WARNING!
Failure to install or use this product according to manufacturer's recommendations may result in property damage, serious injury, and/or death to
those you are seeking to protect!
Do not install and/or operate this safety product unless you have read and understood the safety
information contained in this manual.
1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices are essential to ensure the
safety of emergency personnel and the public.
2. Emergency warning devices often require high electrical voltages and/or currents. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high current arcing, which can
cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation is vital to the performance of this warning device. Install this product so that output performance of the system is
maximized and the controls are placed within convenient reach of the operator so that they can operate the system without losing eye contact with
the roadway.
5. Do not install this product or route any wires in the deployment area of an air bag. Equipment mounted or located in an air bag deployment area
may reduce the effectiveness of the air bag or become a projectile that could cause serious personal injury or death. Refer to the vehicle owner's
manual for the air bag deployment area. It is the responsibility of the user/operator to determine a suitable mounting location ensuring the safety of
all passengers inside the vehicle particularly avoiding areas of potential head impact.
6. It is the responsibility of the vehicle operator to ensure daily that all features of this product work correctly. In use, the vehicle operator should
ensure the projection of the warning signal is not blocked by vehicle components (i.e., open trunks or compartment doors), people, vehicles or other
obstructions.
7. The use of this or any other warning device does not ensure all drivers can or will observe or react to an emergency warning signal. Never take the
right-of-way for granted. It is the vehicle operator's responsibility to be sure they can proceed safely before entering an intersection, drive against
traffic, respond at a high rate of speed, or walk on or around traffic lanes.
8. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying all laws regarding
emergency warning devices. Therefore, the user should check all applicable city, state, and federal laws and regulations. The manufacturer assumes
no liability for any loss resulting from the use of this warning device.
Specifications:
Size: 5590XXX
5590XXX-VM
Weight: Permanent mount
Vacuum-Magnet Mount
Input Voltage: 12 to 48 VDC systems
Installation & Mounting:
IMPORTANT! This unit is a safety device and it must be connected to
its own separate, fused power point to assure its continued operation
should any other electrical accessory fail.
Carefully remove the Minibar and place it on a flat surface. Examine the unit for
transit damage, and locate all parts. If damage is found, or parts are missing,
contact the transit company or CODE 3. Do not use damaged or broken parts.
CAUTION!
When drilling into any vehicle surface, make sure that the area
is free from any electrical wires, fuel lines, vehicle upholstery,
etc. that could be damaged.
Installation and Operation Instructions
15" x 9" x 2.5"
15" x 9" x 3.1"
approx. 4.0 lbs.
approx. 6.3 lbs.
C5590 Series LED Minibar
Current Draw:
Maximum power consumption:
5590: 6.0 Amps Maximum
Maximum power consumption: 84 watts
Flash Rate:
See Flash Pattern Chart
Temp. Range: -30ºC to +50ºC
Page 1 of 6