Beta 1875LT Instrucciones página 28

1f - FOAM FILTER
• Rinse the foam filter with water. DO NOT use detergent
(Fig. "F7")
• Replace if worn or damaged.
2f - EXHAUST FILTERS
• Replace the electrostatic post-filters about every two
months (19).
• To release the grill covers (18) see Figure "F8".
3f - REPLACING DUST BAG (Optional)
The bag should not be reused, always
replace the used bag with a new one.
• Remove the plastic flange (x) from the air inlet connection
(y) (fig "F1").
• Take out the paper filter bag (fig "F2")
• Close the flange with the cap provided (fig "F3").
4f - FILTER (Optional)
• Remove the filter (b) from the motor support (c) (fig. " F4a").
• Clean the filter (b) frequently with a soft-bristled brush (fig. " F4b").
• To clean the filter thoroughly, flush with water from the
inside out (fig. " F5").
• Before replacing the cartridge filter make sure it is completely dry.
• If worn, torn or pierced, replace only the filter element.
When the filter is wet handle with care; do not directly spray
5f - CLEANING THE DRUM
• Check the amount of debris vacuumed particularly if used for voluminous materials.
• We recommend emptying the drum when it is half full.
• After using the appliance as a wet vacuum, empty the drum and dry it and the
attachments to prevent caking.
28
water or do anything else that may damage it (fig. "F6").