Bessey STE Serie Instrucciones De Uso página 4

Telescopic drywall support STE
1
2
4
Inner tube 1
Quick shift button 2
Pump lever 3
Handle 4
Intended use
The telescopic drywall support STE provides temporary support, alignment and
fixing of workpieces to be mounted on the ceiling or on slopes. The telescopic
drywall support must not be used for lifting, pulling or leaning. It must not be used
to secure loads during transport.
Information for safe use
■ Read and observe the operating instructions.
■ The specified load limits must not be exceeded.
■ You may only use the telescopic drywall support on level and clean surfaces.
■ You must not apply lateral loads to the telescopic drywall support support.
■ The the telescopic drywall support may only be tensioned by hand without ad-
ditional aids.
■ You may only use original spare part
■ Protect yourself with safety goggles and an assembly helmet.
Preparation
In the case of an inclined position, you must first secure the telescopic drywall
support on the contact surfaces against slipping. To do this, screw suitable screws
into the holes provided in the upper and lower pressure plates. The screws must be
at least 10 mm longer than the thickness of the pressure plate.
How to proceed
1. Presetting: Press the quick shift key and pull out the inner tube to the desired
length.
2. Fine adjustment: Hold the workpiece firmly with one hand. With the other hand,
operate the pump lever until the pressure plate rests against the workpiece.
3. Fixing: Turn the handle clockwise until the desired holding force is reached.
4. Relax: Turn the handle counterclockwise.
5. Retract: Press the quick shift key. Carefully retract the inner tube with the other
hand as soon as there is no longer any holding force.
4
5
3
9
Screw 5
Contact surface 6
Locking screw 7
Pressure plate 8
6
7
8
Threaded bolt 9
GB