Publicidad
Idiomas disponibles
Idiomas disponibles
To avoid an electric shock hazard, do not under any circumstances:
3-prong plug and corresponding
grounded outlet
•
Minimum ambient operating temperature: 32 °F (0 °C).
•
The correct voltage, frequency, and amperage must be supplied to the
electrical outlet from a grounded, singlephase circuit protected by a properly
sized circuit breaker or time-delay fuse.
- Minimum electrical outlet hole size : 1.5 in
•
The required voltage, frequency, and amperage ratings appear on the product
data label. (See page 2 for location).
Nominal Electrical Supply Requirements
120 Vac, 60 Hz, 15 Amp., dedicated circuit The warming drawer is supplied
with a 79" (200 cm) power cord with a 3-prong grounded plug.
Total Connected Load 0.5 kW (4 Amp.)
The above power supply requirements are for reference only. Always use the
•
requirements on the appliance label.
•
The owner ensure the electrical outlet is installed by a qualified electrician; the
installation must comply with the latest revision of the National Electric Code
ANSI/NFPA 70, and local codes and ordinances.
•
If the electrical service provided does not meet the product specification, or
does not conform to the NEC or local standards, call a licensed electrician to
correct the electrical service before proceeding with the installation.
•
Install the electrical outlet in an accessible location so the warming drawer
may be easily unplugged for servicing.
•
Keep the electrical cord away from hot surfaces.
DG68-01562A-00_IM_DWR30U900WP_DA_EN+MES+CFR.indb 7
DG68-01562A-00_IM_DWR30U900WP_DA_EN+MES+CFR.indb 7
•
Cut or remove the third (ground)
prong from the power cord.
•
Use an adapter plug.
Use a power cord that is frayed or
•
damaged.
•
Immerse the power cord or plug in
water or other liquid.
•
Connect the appliance to an extension
cord.
(36 cm
)
2
2
Installation Instructions
WARNING
•
To avoid personal injury caused by the appliance falling forward when the
drawer is opened, secure the chassis to the cabinet and support platform as
instructed.
•
Be certain that the power plug is disconnected from the electrical outlet
before installation.
•
Verify that the electrical supply matches the ratings found on the appliance
data plate and the installation specifications before proceeding.
Removing the Drawer
Remove the drawer from the appliance to allow access to the mounting holes
during installation, and to reduce weight:
STEP 2:
Push locking
tab
STEP 3:
Pull front of
drawer
1.
Pull the drawer out to the fully open
position.
2.
Push on the locking tab on both sides
as you pull the drawer.
3.
For safety, push both drawer slides
into the drawer opening.
English 7
2023-06-13 오전 9:13:02
2023-06-13 오전 9:13:02
Publicidad
