Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting hole, 8 places
Mounting Hole Locations
(This model do not have
a flange around the edge
of the front frame)
Cabinet
Chassis
Less than 3/32"(2.5 mm)
*Left and right symmetric
DG68-01562A-00_IM_DWR30U900WP_DA_EN+MES+CFR.indb 9
DG68-01562A-00_IM_DWR30U900WP_DA_EN+MES+CFR.indb 9
4.
Use the screws provided to secure the
warming drawer chassis to the cabinet
and support platform. Disassemble
the drawer from the chassis first,
and then insert the screws into the
mounting holes and tighten into place.
You may want to drill pilot holes prior
to installing the mounting screws.
After that, insert the drawer into the
chassis.
NOTE
It is recommended to prevent one side
position of product in cabinet use a
temporary spacer(such as Steel ruler, etc)
according to the size of the furniture and If
you fix product by mounting hole, please
fix left and right.
Re-installing the Drawer
1.
Push the rail until it reaches the end
of the chassis.
2.
Pull out the retainer to the front of
the rail.
3.
Slightly insert one side of the drawer's
rail into the chassis rail.
Repeat the same process on the
4.
opposite side.
5.
Gently open and close the drawer to
make sure that it is properly installed.
English 9
2023-06-13 오전 9:13:03
2023-06-13 오전 9:13:03
Publicidad
