iOttie Auto Sense 2 Manual Del Usuario página 5

02 Installation
Assembling the Mount
1. Connect the mount cradle to the
ball joint.
Attaching the Mount
Choose an installation method: Dashboard/Flat Surface (A) or
Windshield/Curved Glass (B).
If your vehicle has a leather dashboard, we recommend windshield
!
mounting to avoid damaging your dash.
[ Option A ]
Dashboard or Flat Surface Installation
Choose a flat location on the vehicle's dashboard and wipe any
dust or debris from the surface.
20
1
min
3
2
8 EN
2. Tighten the cradle knob.
1. Peel off the film on the dashboard
pad and evenly press onto the desired
installation location. Wait at least 20
minutes before attaching the mount to
ensure a secure hold.
2. Remove the plastic cover from the
suction cup and firmly press the mount
onto the dashboard pad.
3. Push the locking lever down to
engage suction.
• The dashboard pad is mounted with a semi-permanent adhesive tape.
Once removed, it cannot be re-mounted.
• When mounting, it is recommended that the surface and product be above 65F.
• When removing the dashboard pad, please use caution. We recommend removing
slowly from the edge to avoid damage.
[ Option B ]
Windshield or Curved Glass Installation
Choose a location on the windshield and wipe any dust or debris
from the surface.
1
2
Note: To reuse the suction cup,
simply rinse under warm water and
let air dry to restore tacky suction.
*The dashboard pad is not
recommended for windshield
mounting.
1. Peel off the protective film on the
suction cup and press the mount
firmly onto the windshield.
2. Pushing the locking lever down
to engage suction.
9