CAB THUMB32 Manual Del Usuario página 23

6.5) ASSOCIATING A BUTTON
For regular 2 and 4 channel transmitters, each button bears a code that distinguishes them: B1/B2 for two-channel and B1/B2/
B3/B4 for four-channel. Some receivers are able to automatically assign specific functions to each button.
In the THUMB32, each channel (CH) corresponds to a two-channel transmitter where:
- the button is the button B1 (default)
- the button is the button B2 (default)
It is possible to relink the two buttons. Proceed as follows:
1) press the button and hold it down for at least 5 sec to enter the setup menu
2) scroll through the menu using the keys
3) select with the buttons
button.
4) select (UP or DOWN) the button you want to set, confirm with the
5) select which function to assign (Btn1/Btn2/Btn3/Btn4), confirm with the button
The display shows OK to confirm the programming.
6.6) DELAY FUNCTION
The simultaneous movement of several automated systems can cause, in some cases, problems to your network security device
(differential). Therefore, it is better to set a delay time between a command and the next. The factory preset delay value is 0.1
seconds. To increase it up to 2 seconds, perform the following steps.
1) press the button and hold it down for at least 5 sec to enter the setup menu
2) scroll through the menu using the keys
3) select with the buttons
4) Press to confirm
The display shows OK to confirm the programming.
7) WASTE DISPOSAL
As indicated by the symbol shown, it is forbidden to dispose this product as normal urban waste as some parts
might be harmful for environment and human health, if they are disposed of incorrectly. Therefore, the device should
be disposed in special collection platforms or given back to the reseller if a new and similar device is purchased.
An incorrect disposal of the device will result in fines applied to the user, as provided for by regulations in force..
or until reaching the btn mode, confirm with the button
or button the channel (CH) for which you want to set the buttons
or until reaching the dly mode, confirm with the button
or ibutton the delay time (the value is expressed in tenths of a second).
button.
.
ENG
or , confirm with the
23