Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: The tube clamp b ase has four
spacer tabs attached. These t abs are
provided toadapt this attachment
for
usewith powerheads
thathave a 1"di-
ameter upper tube (the tube clamp w ill
nottighten d own s ecurely onthe1"di-
ameter upper tube without using t hese
spacer tabs). T he tabs must bebroken
offcompletely before u se and placed
over t hescrew holes o ntheclamp b ase.
These t abs arenotneeded forpower-
heads w itha7/8" upper tube.
HANDLEBAR
CLAMP B ASE
Spacer Tabs
Spacer Tabs _
o °ai i° e rer ae
upper tube
_I
1.
Place the tube clamp over the upper
tube above the arrow on the safety
decal.
2.
Position the clamp base under the
upper tube and align the tube clamp
and clamp base screw holes (use
spacer tabs between tube clamp
and clamp base if necessary to se-
cure clamp, i.e. for 1" diameter up-
per tube).
Handlebar
POWERHEAD
END
Handlebar Clamp
between arrows on
handlebar decal
Clam
Knob
Clamp
Screws
Arrow on
Safety Decal
ATTACHMENT
END
3.
Insert four screws into the screw
holes.
4.
Secure tube clamp by tightening
screws with the hex wrench.
5.
Position the handlebar as shown,
ensuring the handlebar is posi-
tioned on the handlebar clamp be-
tween the two arrows on the han-
dlebar decal.
6.
Retighten handlebar byturning
clamp knob clockwise until handle-
bar is secure and stationary in
clamp (clamp knob cannot be
overtightened).
SHOULDER STRAP ASSEMBLY
_1_ WARNING:
Proper shoulder
strap and handlebar adjustments
must
be made with the engine completely
stopped before using unit. The shoul-
der strap clamp must be installed as
shown above the handlebar on the up-
per tube (powerhead end of unit).
NOTE: The lower shoulder strap clamp
has two spacer tabs attached. These
tabs are provided to adapt this attach-
ment for use with powerheads that have
a 1" diameter upper tube (the shoulder
strap clamp will not tighten down se-
curely on the 1" diameter upper tube
without using these spacer tabs). The
tabs must be broken off completely be-
fore use and placed over the screw
holes on the lower shoulder strap clamp.
These tabs are not needed for power-
heads with a 7/8" upper tube.
LOWER SHOULDER STRAP
CLAMP
Spacer Tabs_'r
_
.,dC_L.4--_ _- Spacer Tabs
I1_-_
positioned for use
on 1" diameter
upper tube
1,
2.
Place the upper shoulder strap
clamp over the upper tube above
the handlebar.
Position the lower shoulder strap
clamp under the upper tube and
align the upper and lower clamp
screw holes (use spacer tabs be-
tween upper and lower clamps if
necessary to secure clamp, i.e. for
1" diameter upper tube).
Publicidad
