Craftsman 358.797560 Manual De Instrucciones página 5

SHOULDER STRAP ASSEMBLY
(for blower use only)
1. Pass the shoulder strap over your
head and onto your left shoulder.
2. Snap the hook onto the retainer on
the top handle.
_ Retainer
VACUUM ASSEMBLY
VACUUM BAG ASSEMBLY
If you have already assembled your
unit for use as a blower, remove the
blower tube, nozzle and shoulder
strap.
1. Open the zipper on the vacuum
bag and insert the elbow tube.
2. Push grooved end of the elbow
tube through the small opening in
the bag.
Elbow Tube
Small
Opening
Zipper Opening
NOTE: Make sure edge of the small
opening is flush against the rib on the
elbow tube.
3. Close the zipper on the bag. Make
sure the zipper is closed completely.
4. Insert the elbow tube into the blow-
er outlet by placing tabs (inside
blower outlet) in grooves and turn-
ing counterclockwise until locked in
position.
VACUUM TUBE ASSEMBLY
1. Align slanted end of lower vacuum
tube as shown. Firmly push lower
vacuum tube into upper vacuum
tube.
Upper vacuum tube
2. Insert a screwdriver under the tab
in the latch area on vacuum inlet
cover.
-5-
Latch _---_ _
] _
_
Blower
Area "l Out et
/_ Latch Area
Vacuum
[_= Inlet Cover
3. Gently tilt the handle of the screw-
driver forward toward blower outlet
while pulling up on the vacuum in-
let cover with your other hand.
4. Hold the vacuum inlet cover open
until upper vacuum tube is installed.
5. Assemble upper vacuum tube to unit
by placing locking tabs (located in-
side vacuum inlet) in grooves on
tube; turn clockwise to tighten.
6. When converting back to the blow-
er feature, make sure latch on the
vacuum inlet cover is securely fas-
tened.
Blower Outlet
Slanted End
of Lower
Vacuum Inlet Cover
Locking Tabs
SHOULDER STRAP ADJUSTMENT
(for vacuum bag)
1. Hold the unit as shown.
2. Pass the shoulder strap over your
head and onto your left shoulder.
3. Snap the hook onto the retainer on
the top handle.
4. Extend your right arm toward the
rear of the vacuum bag.
5. Adjust shoulder strap until the vacu-
um bag/shoulder strap seam lies be-
tween your thumb and index finger.
6. Make sure air flows freely from the
elbow tube into bag. If bag is
kinked, the unit will not operate
properly.