Publicidad
Idiomas disponibles
Idiomas disponibles
English
nOTE: Ensure both battery packs are fully seated and
fully latched into position before starting mower.
3. Close the battery port cover
closed before starting mower.
To Remove the Battery Packs
1. Lift and hold the battery port cover
battery port
38
.
2. Depress the battery release button
battery packs
26
and pull the battery packs out of the
battery port
38
.
Safety Key (Fig. T)
DANGER: Sharp moving blade. In order to prevent
accidental start‑up or unauthorized use of your
cordless mower, a removable safety key has been
incorporated into the design of your mower. The mower
will be completely disabled when the safety key has
been removed from the mower.
DANGER: Rotating blades can cause serious
injury. To prevent serious injury, turn unit off and
remove safety key and battery packs when unattended,
or when charging, cleaning, servicing, transporting,
lifting, or storing mower.
1. Insert safety key
6
into the key slot
the main handle
4
, until it is fully seated inside of the
key slot
50
as shown in Fig. T.
2. The mower is now operational.
Control Panel Indicators (Fig. A, U)
The control panel
12
contains the state of charge indicator,
load meter indicator, temperature indicator, handle folding
indicator, blade sharpening indicator and reset button.
State of Charge Indicator (Fig. U)
The DCMWP234 and DCMWSP256 are equipped with a
state of charge indicator. This will display the current level of
charge in the batteries during use. It does not indicate tool
functionality and is subject to variation based on product
components, temperature and end-user application.
•
The state of charge indicator LEDs
indicating the percent of charge in the batteries.
•
When all 5 state of charge indicator LEDs
the batteries are fully charged.
•
When one state of charge indicator LED
charge is low and then it will flash when the batteries
are discharged. Remove the batteries and charge them.
18
19
. Ensure the cover is fully
19
up to expose the
27
on the
50
, located on
18
will illuminate,
18
illuminate,
18
illuminates,
State of Charge Indicator LED Status
LEVEL OF CHARGE
100% - 85%
70% - 85%
50% - 70%
25% - 50%
≤25%
Low battery shutdown
Handle Folding Indicator (Fig. U)
The handle folding indicator
single touch handle
1
is not engaged in the operating
position. To clear the handle folding indicator
the Raise the Single Touch Handle section in this manual.
Cutting Load Meter Indicator (Fig. U)
The cutting load meter indicator
yellow or red when mowing.
•
White indicates a low cutting load.
•
Yellow indicates a medium cutting load.
•
Red indicates a high cutting load. Runtime will be
reduced if there is a prolonged high load while mowing.
Overheat Indicator (Fig. U)
•
The overheat indicator
then blink when the batteries or motor is overloaded
during operation.
•
The overheat indicator
blink when the module has reached a high temperature.
CHARGE INDICATOR
LED COLOR
White
White
White
White
White
White and blinking
15
will illuminate when the
15
, refer to
14
will illuminate white,
13
will illuminate amber and
13
will illuminate red and then
Publicidad
