Craftsman 875.167061 Manual Del Propietário página 3

i_ M4orethanl/100slope
Branch line = 2 times I Stop Filter am. me = lmes _-4
Tool inlet/hose size / Valve Regulator Tool inlet/hose size
I
_ _ Stop _ /
Auto Drain _ _ ValveW_::::_
w,ve II
Air Tool _-,.I
bAuto Drain
_ ( Air C ......... _1
Valve Air HFigHrelk Up
Always wear head and face protection, long sleeve, jacket
pants, work shoes and rubber gloves. Wear a respirator.
Protect other people. Allow no one in the blasting area
unless they are wearing safety equipment.
Sand hitting metal can cause a spark., NEVER work near
oily rags, gas tanks or flammable liquids.
Never point the sand blast stream at any person or part of
the body. Always depressurize and disconnect incoming
air hose when sandblaster is unattended.
Check and tighten sand hose clamps and check other
fittings for leaks and wear. Watch for loose or worn hose
and fittings and replace as needed.
Prior to adding abrasive, fully pressurize the unit to check
all hose and pipe fitting for tightness. Check the operation
of all valves and other components. Check for air leaks
and tighten as necessary. Turn the sandblaster on and off
several times to become familiar with the operation.
[ WARN|N I
Only after reading the safety instructions and testing the
unit without sand, you may then add sand and start to
sandblast