Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL OPERATION
FUNCTIONS:
With the slide switch in the REMOTE position, the system will only operate
•
if the remote receiver receives commands from the transmitter.
Upon initial use or after an extended period of no use, the ON button may
•
have to be pressed for up to three seconds before activating servo motor. If
the system does not respond to the transmitter on initial use, see
LEARNING TRANSMITTER TO RECEIVER.
With the slide switch in the ON position you can manually turn ON the
•
system.
With the slide in the OFF position, the system is OFF.
•
It is suggested that the slide switch be placed in the OFF position if you will
•
be away from your home for an extended period of time.
Placing the slide switch in the OFF position also functions as a
•
safety "lock out" by both turning the system OFF and rendering the
transmitter inoperative.
INSTALLATION INSTRUCTIONS
DO NOT CONNECT REMOTE RECEIVER DIRECTLY TO 110-120VAC POWER. THIS WILL BURN
DO NOT CONNECT REMOTE RECEIVER DIRECTLY TO 110-120VAC POWER. THIS WILL BURN
OUT THE RECEIVER. FOLLOW INSTRUCTIONS FROM MANUFACTURER OF GAS VALVE FOR
OUT THE RECEIVER. FOLLOW INSTRUCTIONS FROM MANUFACTURER OF GAS VALVE FOR
CORRECT WIRING PROCEDURES.
CORRECT WIRING PROCEDURES. IMPROPER INSTALLATION OF ELECTRIC COMPONENTS CAN
CAN CAUSE DAMAGE TO GAS VALVE AND REMOTE RECEIVER.
CAUSE DAMAGE TO GAS VALVE AND REMOTE RECEIVER.
INSTALLATION
The remote receiver can be mounted on or near the fireplace hearth. PROTECTION FROM EXTREME HEAT IS VERY IMPORTANT.
Like any piece of electronic equipment, the remote receiver should be kept away from temperatures exceeding 130º F inside the
receiver case. Battery life is also significantly shortened if batteries are exposed to high temperatures.
HEARTH MOUNT
The remote receiver can be placed on the fireplace hearth or under the fireplace, behind the
control access panel. Position where the ambient temperature inside the receiver case does not
exceed 130º F. NOTE: Black Button is used on Hearth Mount Applications.
WIRING INSTRUCTIONS
Make sure the remote receiver switch is in the OFF position. For best results it is recommended
that 18 gauge stranded wires should be used to make connections and no longer than 20-feet.
Pulse Connection
Concentric Valve
Red Wire
IMPROPER INSTALLATION OF ELECTRIC COMPONENTS
This CON1001 TH remote receiver is to be connected
to a manual valve with a latching ON/OFF solenoid.
Connect two 18 gauge stranded or solid wires from the
remote receiver terminals to the latching solenoid.
(See figure to the right)
IMPORTANT NOTE:
Black Wire
dependent on which wire is attached to which terminal.
If operation of control does not correspond to operating
buttons on transmitter, reverse wire installation at the
receiver or at the control.
WARNING
Operation of this control is
31
Remote Receiver
Wire terminals
Receiver
Slide
Button
LEARN
REMOTE
Remote Receiver
Wire terminals
Receiver
Slide
Button
REMOTE
Receiver
Slide
Button
REMOTE
ON
Remote Receiver
LEARN
PULSE MODE
Terminals
LEARN
Publicidad
