Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL OPERATION
BATTERY LIFE
Replace all batteries regularly. When the transmitter no longer operates the remote receiver from a distance it did previously (i.e., the
transmitter's range has decreased) or the remote receiver does not function at all, the batteries should be checked. It is important that
the remote receiver batteries are fully charged, providing combined output voltage of at least 5.5volts. The handheld transmitter should
operate with as little as 2.5 volts battery power.
TROUBLESHOOTING
If you encounter problems with your fireplace system, the problem may be the fireplace itself or it could be with the remote
system. Review the fireplace manufacturer's operation manual to make sure all connections are properly made. Then check the
operation of the remote in the following manner:
Make sure the batteries are correctly installed in the RECEIVER. One reversed battery will keep receiver from operating properly.
•
Check battery in TRANSMITTER to ensure contacts are touching (+) and (-) ends of battery. Bend metal contacts in for tighter fit.
•
Be sure RECEIVER and TRANSMITTER is within 20-feet operating range.
•
Clear Codes: Memory in the receiver might be full if the learn button is pressed too many times. If this happens it will not allow any
•
more codes to be learned and no audible beep will be heard. To clear memory, place the receiver slide switch into the REMOTE
position. Press the learn button and release after 10 seconds. You should hear three (3) long audible beeps indicating all codes
have cleared. You can now "learn" the transmitter to the receiver as described in the General Information Section.
Keep RECEIVER from temperatures exceeding 130° F. Battery life shortened when ambient temperatures are above 115° F.
•
If RECEIVER is installed in tightly enclosed metal surround, the operating distance will be shortened.
•
Rechargeable batteries should not be used. They do not supply sufficient power to operate the remote system.
•
SPECIFICATIONS
BATTERIES:
Transmitter (2) 1.5 volt AAA batteries
Remote Receiver 6V - 4 ea. AA 1.5 Alkaline
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
FCC REQUIREMENTS
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT.
FCC ID No.'s: transmitter - 2ARLSGH03-C
33
Publicidad
