Bresser MeteoTemp Baro HZ colour Manual De Instrucciones página 19

13 Indoor temperature
15 Comfort indicator (climate)
17 Trend arrow humidity (indoor)
19 Icon outdoor temperature
21 Trend arrow outdoor temperature
23 Ice alert (frost warning)
25 Humidity (outdoor)
27 Hour display for barometer reading
29 Barometer (air pressure)
7 Setting the city
Manually set the city near you as follows to ensure that the moon phases, tides, sunset and sunrise
are displayed correctly.
1. press the CITY button.
2. Press the UP or DOWN button to set the desired city.
3. Press the CITY button again.
Setting your own city:
In normal mode, press and hold the CITY button for about 3 seconds to call up your own city, the
digits to be set flash, press the UP or DOWN button to change the value, and press the CITY button to
move to the next setting. The order of setting is The first letter for the city name (A-Z) > The second
letter for the city name (A-Z) > The third letter for the city name (A-Z) > GMT time > Longitude >
Latitude
Finally, press the CITY button to save the settings and exit the CITY setting mode.
City code
You can find a list of cities as a PDF file at: www.bresser.de/download/City_Codes
8 Before commissioning
NOTICE
Avoid connection faults!
In order to avoid connection problems between the devices, the following points must be observed
during commissioning.
1. Place the base unit (receiver) and sensor (transmitter) as close together as possible.
2. Connect the power supply to the base unit and wait until the indoor temperature is displayed.
3. Establish power supply for the sensor.
4. Set up/operate the base unit and sensor within the effective transmission range.
5. Make sure that the base unit and the radio sensor are set to the same channel.
When changing the batteries, always remove the batteries from both the base unit and the sensor and
reinsert them in the correct order so that the radio link can be re-established. If one of the two devices
is operated via a mains power connection, the power connection must also be briefly disconnected for
this device when the batteries are changed. If, for example, only the batteries in the sensor are
replaced, the signal may subsequently not be received at all or not be received correctly.
14 Trend arrow indoor temperature
16 Icon humidity
18 Humidity (indoor)
20 Outdoor temperature
22 Icon humidity (outdoor)
24 Trend arrow humidity (outdoor)
26 Selected channel of the wireless sensor
28 Moon phases / tides
30 Histogram
19 / 72