VONROC PD501AC Traducción Del Manual Original página 11

DESCRIPTION
The numbers in the text refer to the diagrams on
pages 3-6.
1. Drill housing
2. Cover cap
3. Bolt for drill depth handle
4. Drill depth handle
5. Baseplate
6. Hex key
7. Protective guard
8. Screw for protective guard
9. Quick-action clamp
10. Quick-clamping lever
11. Machine vice (75mm jaw width)
12. Spring washer for vice
13. Washer for vice
14. Nut for vice
15. Bolt for vice
16. Parallel fence
17. Square nut for fence
18. Knob for fence
19. Gear selector
20. Laser
21. LED worklight
22. Drill bit accessory
23. Pillar
24. Mounting holes
25. Vice lever
26. Chuck
27. Lower chuck sleeve
28. Upper chuck sleeve
29. On/Off switch
30. Display
31. Depth stop knob
32. Depth scale
33. Height adjustment lever
34. Baseplate bolt
35. Power cable
36. Pillar lever
37. Drill depth handle shaft
38. Power button
39. Speed or depth selection button
40. Decrease speed button
41. Increase speed button
42. Laser / LED worklight button
43. Zero-point button
44. Laser adjustment screw
WWW.VONROC.COM
3. ASSEMBLY
Before carrying out any work on the
machine, disconnect the mains plug from
the power supply.
Checking the product and scope of delivery
• Take the pillar drill and accessories out of the
packaging.
• Check whether the delivery is complete (see
figure "package contents").
• Check the pillar drill and accessories for dama-
ges.
• Do not use the pillar drill if it is damaged or
parts are missing. Contact Vonroc customer
service.
Assembling the pillar to the base (Fig. C, D)
1. Place the baseplate (5) on a flat surface.
2. Insert the pillar (23) of the drill (1) into the hole
of the baseplate (5), as shown on figure C1.
Ensure the chuck is properly aligned, that is
to say positioned above the centre hole of the
baseplate (5).
3. Fix the pillar (23) to the baseplate (5) by tighte-
ning the bolt (34) using the hex key (6).
4. Finally, place the cover cap (2) on the pillar
(23), as shown on figure D.
Mounting the drill depth handle (Fig. E, F)
Be careful when mounting the feed handle
to ensure that the mating surfaces properly
fit with each other.
1. Mount the drill depth handle (4) onto the shaft
(37), as shown on figure E.
2. Fix the drill depth handle (4) to the shaft (37)
using the bolt (3) and a PH2 Phillips screwdriver
(not included in the supply).
Mounting the protective guard (Fig. G)
Risk of injury! The pillar drill should not be
operated without the protective guard.
• Insert the protective guard (7) onto the housing
part with holes as shown on figure G.
• Fix the protective guard (7) with the screws (8)
or the right and left sides using a PH2 Phillips
screwdriver (not included in the supply).
EN
11