Publicidad
Idiomas disponibles
Idiomas disponibles
Fig.1.-
(1) Bottom frame.
(2) Selector post.
(3) Weight guide bars
(6) Bottom washer.
(7) Top cap
(11) Weight.
(12) Upper stop weights.
(13) Selector
(14) Main body.
(18) Support.
(21) Left lateral tube.
(22) Right lateral tube.
(23) Lateral pulley support.
(25) Plate.
(26) Left Butterfly arm.
(27) Right Butterfly arm.
(28) Lateral support.
(29) Butterfly arm support.
(33) Knob.
(34) Seat support tube.
(35) Seat support.
(36) Leg support.
(37) Footrest.
(38) Spacer.
(40) Foam.
(41) Inside cap.
(42) Exterior cap.
(44) Levelling feet.
(45) Knob.
(46) Pulley sheet.
(47) Pulley.
(51) Guide.
(53) Lateral cable.
(54) Sheet.
(56) Lift Leg cable.
(57) Butterfly arm cable.
(58) Big tensioner.
(59) Small tensioner.
(60) Backrest.
(62) Seat.
(64) Leg bottom support shaft.
(65) Leg top support shaft.
(66) Chain.
(67) Chain.
(68) Security cover.
(70) Handle.
NUTS & BOLTS
(4) Washer D10.
(5) Hex screw M10x20.
(8) Locked nut M8.
(9) Hex screw M8x70.
(10) Washer D8.
(15 Hex screw M12x60.
(16) Washer D12.
(17) Locked nut M12.
(19) Hex screw M10x70.
(20) Locked nut M10.
(24) Hex screw M12x70.
(30) Washer D25xD10,5
(31) Allen screw M10x16.
(32) Hex screw M12x30.
(39) Spring washer D10.
(43) Allen screw M8x25.
(48) Screw M8x48.
(49) Hex screw M10x45.
(50) Cap D22xD10,5.
(52) Hex screw M10x60.
(55) Hex screw M10x115.
(61) Hex screw M8x16.
(63) Hex screw M8x40.
(69) Hex screw M8x20.
Thread the levelling feet (44) onto
the frame (1), Fig.2.
Fit the weight guide bars (3) on the
main support (1), Fig.2, fit screws (5)
along with the washers (4) and
tighten securely.
Now fit the bottom washer for the
weights (6) Fig.2.
Place the weights (11) onto the
guide bars as shown in Fig.2.
Now take the weight selector post
(2), Fig.2 and the upper stop for the
weights (12), and insert it onto the
last weight, fit the selector ring (13)
onto the central boss on the weight
selector post, as shown in Fig.2.
14
Publicidad
