Transporting/Operation - ryan RENOVAIRE 744317A Manual Del Operador

TRANSPORTING/OPERATION

RENOVAIRE
TRANSPORTING
This unit is not designed nor meant to be towed at speeds in excess of 10 MPH (16 Km/h).
Towing at excessive speeds will cause damage to frame and/or wheels. This type of damage will not
be repaired under the terms of the warranty.
1. Raise the aerating wheels high enough to hook the eye bolts 11, Figure 1 onto the latch hooks on the side
of the cradle assembly.
2. Lower the aerating wheels until the eye bolts are supporting the cradle assembly.
OPERATION
Before operating, check the area to be aerated and remove any objects which may present a safety
hazard or which may damage the aerator (rocks, cans, etc.).
Underground Utilities
Electrocution, Explosion, Service Disruption Risk
Before beginning any work check with the local authorities for underground utility location and depth.
Contacting buried utilities could result in a service outage.
Contacting buried electrical utilities could result in electrocution.
Contacting a buried gas line could result in an explosion.
Be certain utilities are deep enough before operating over them.
Do not leave the tractor unattended without first lowering the aerator and stopping the engine.
To prevent possible injury, do not operate aerator without weight trays in place. Do not make any
adjustments or perform any maintenance while tractor is running.
1. Position tractor and equipment where aerating is to begin.
2. Lower aerating wheels and proceed to aerate.
NOTE:
Never cross hard surfaces (sidewalks, driveways, stepping stones etc.) with the tines down.
To prevent turf damage, aerator must be raised completely out of the ground while turning the tractor.
Do Not back up when the tines are in the ground or damage to the tines and clamps may occur.
When aerating soft ground and full penetration is not desired, the depth may be controlled by raising the
cradle assembly with the hydraulic system.
Failure to lubricate the aerating wheels can cause damage to the axles, bushings and the wheels.
7