Publicidad
Idiomas disponibles
Idiomas disponibles
Assemble Mounting Brackets
Toassemblethe baggermountingassembly,locatethe hitch bracket
kit and follow thesesteps:
1.
Attachthe right-handand left-handrider hitchbracketto the
universalrearattachmentbracketusingthe four carriagebolts
(710-0276) and flange lock nuts(712-04063)from hardware
pack689-00097. Positionthe bracketswith the notcheson the
right-handand left-handrider hitch bracketsand the tabs on the
universalrearattachmentbracket,pointingupwards.See Fig. 1.
.
Flipoverassemblyand mountthe hitch supportbracketto the
mountingassemblyusingfour 710-3008 hex bolts and 712-04063
flangelock nuts from hardwarepack689-00097.See Fig.2 for
properorientation.
NOTE: Whenattachingthehitch support,it is best to notfully tighten
the bracketat this time. This willfacilitatethe mountingprocessin
later steps,whichwill then requirefully tighteningof this hitch support
bracket.
NOTE:This universalmountingbracketassemblyis designedto
workwith otheravailableattachments,such as a weightkit used in
conjunctionwith the snowblade or snowthrowerattachment.Utilize
thecontact informationon the back page,or contactthe store in
whichyou purchasedthis equipment,to find out moreaboutavailable
attachments for your specifictractor.
Figure 2
NOTE:Packedwith the uprightmountingbracketare two mounting
bracketswith hardwareusedon anothermodeltractorand will notbe
neededin this installation.Simplydiscardthe parts shownbelowin
Fig.3.
.
Figure 1
Figure 3
8
Publicidad
