Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Installing The Wheel Base To The Ground
NOTE: Installing the tab into the slot on the pedestal base bracket secures the mast to the base to prevent the
crane from rotating and possibly tipping under load.
1. Ensure there is a level foundation that can properly support Wheel Base under all conditions.
2. Assemble the Wheel Base according to instructions previously stated in this manual.
3. Install anchors to the surface that Wheel Base will mount to, at the location desired. Use Figure 10.1 for measurements.
NOTE: 1/2"-13 Grade 5 is the recommended bolt size to mount the Wheel Base.
4. Move Wheel Base into position where it is to be anchored.
5. Install four (4) supplied bolts and four (4) washers through the anchor point tubes and torque to twenty (20) foot-
pounds. See Figure 10.2.
WARNING
CAUTION
Dimensional values are provided in inches. Bracketed values [ ] within diagram
represent equivalent measurements in millimeters for informational purposes only.
20
Failure to install the tab into the slot on the pedestal base bracket may result in the
crane tipping under load.
Factory supplied wheel base mounting bolts and washers to be used for fl oor-
mounting with anchors only.
Figure 10.1
Wheel Base Operator's Manual • OZ Lifting Products, LLC
Moun ng Bolts
Washers
Figure 10.2
®
• 1/2024
Publicidad
