Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE THE ACCESSORIES
1) REPLACE DIFFERENT FILTERS
▶There is a notch on the side of the portafilter as mark 1
▶Take out the fixed filter from the notch, take out the filter as in step
2.
▶Then press the new filter into the holder.
2) INSTALL THE FILTER HOLDER ON THE MACHINE
▶Step 1: Align the handle with the '·' mark on the left side of the
machine.
▶Step 2: Rotate the bracket to the '· ·' location and lock it.
3) DIFFERENT CUPS
▶Drip tray is detachable to fit different cups.
HOW TO MAKE COFFEE
TIPS
▶Preheat the machine when it has not been used for a long time.
▶It is recommended to use the function without coffee powder for the
first cup, to allow the machine to warm up.
▶After making the first cup of coffee, it is recommended to let the
kettle cool down first, otherwise the kettle will burn or overheat.
Turn the steam dial to release hot water until the pump stops
running. Then close the steam dial to the O position.
1.Select the desired filter and check for any residue.
Instruction manual
2.Check and make sure there is enough water in the tank.
3.Fix the filter to the filter holder and fill the coffee powder
into the filter evenly and press lightly with the flat end of
the spoon.
4.Lock the bracket on the machine.
5.For pre-ground coffee powder:
HOW TO ADJUST THE DEFAULT COFFEE
VOLUME
If you find that the default volume of brewed coffee is too much or less,
you can reset it.
1. Fill the coffee into the 1-cup or 2-cup filter holder
2. Press 'Single Cup Coffee Button' or 'Two Cup Coffee Button'
for 3 seconds, then the LED light on the button will flash, the
pump will start to work and coffee will be brewed.
3. Once you reach the desired volume, press the same button
again. Then finish setting the default volume. The machine
will prepare the new adjustment volume next time.
4. If you need to return to the original settings, please long
press the "ON/OFF" button for 3 seconds to restore.
HOW TO MAKE CAPPUCCINO
1. Prepare the coffee as 'HOW TO MAKE COFFEE'.
2. Press the "Steam" button and its light will flash, wait until
the light is always bright, then it is ready to froth milk or
draw hot water.
3. Place an empty container under the milk froth tube and
turn the dial to the steam position for 3-5 seconds to clean
the tube. Close the dial after cleaning.
4. Pour about 100g of milk into a large cup.
Tips: use semi-skimmed milk at refrigerator temperature.
5. Put the cup of milk under the milk froth tube and make
sure the spout of the tube is submerged in the milk.
6. Turn the dial to the Steam position to froth milk.
• A good espresso is related to the correct pressing.
• If it is too firm, the coffee will be strong.
• If it is too light, the coffee will be weak.
ref. 07707
ES
PT
EN
FR
Publicidad
