Descargar Imprimir esta página

Craftsman WEEDWACKER 358.795920 Manual Del Operador página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

Gearbox
/
Shield
Aligned holes J _
Dust cup
_l
Threaded shaft
Re_
de
Washer _
Cupped ..... _
Washer
_i_-,t
Nut
NOTE: Make sure all parts are in place
as illustrated, and the blade is sand-
wiched between the dust cup and the
retaining washer. There should be no
space between the blade and the dust
cup or the retaining washer.
7. Align hole in dust cup with hole in
side of gearbox by rotating the
blade.
8. Insert a small screwdriver
into
aligned holes. This will keep the
shaft from turning while tightening
the blade nut.
9.
Tighten blade nut firmly with a
wrench while holding screwdriver in
position.
10. Remove the screwdriver.
11. Turn blade by hand. If the blade
binds against the shield, or appears
to be uneven, the blade is not cen-
tered, and you must reinstall.
NOTE:
To remove blade, insert screw-
driver into aligned holes. Unthread the
nut and remove parts. Be sure to store
parts and instructions for future use.
KNOW YOUR WEEDWACKER
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location of
the various controls and adjustments.
Save this manual for future reference.
Handlebar
Brushcutter
Attachment
Blade
Assist Handle
__
_'
\
/
(2"i\\
._._
_
Coupler
_,_k
__,_
_1
Shield
Shaft
i
_'__
_.
_.
__)
ON/STOP Switch
I_reJamdmer .
_"
Primer B_lb
Starter Handle
.,_ --Shield
/
Muffler
Line Limiter
Blade
Throttle Trigger
/
Start Lever
11

Publicidad

loading