Publicidad
Idiomas disponibles
Idiomas disponibles
stated in the applicable attachment op-
erator's manual. Using the wrong hole
could lead to serious injury or damage
to the unit.
Locking/Release
Button in Primary
Hole
OPERATING
INSTRUCTIONS
To maximize operating efficiency, do
not run the engine for longer than 1
minute at a time at full throttle.
OPERATING
POSITION
ALWAYS USE:
Hearing
J-t
Protection
Eye Protection
Long
Pants
Heavy
_,I_
Shoes
Cutfrom
yourle_to
yourright.
When operating
unit, stand as shown
and check for the following:
• Wear eye protection,
hearing protec-
tion and heavy clothing.
• Hold trigger handle with right hand
and assist handle with left hand.
• Hold unit so that engine is below
waist level.
• Cut only from your left to your right to
ensure debris is thrown away from
you. Without bending over, keep the
blade or trimmer head near and par-
allel to the ground and not crowded
into material being cut.
OPERATING
INSTRUCTIONS
FOR
USE WITH TRIMMER
HEAD
WAR NI N G: Always wear eye
protection. Never lean over the trimmer
head. Rocks or debris can ricochet or
be thrown into eyes and face and
cause blindness or other serious injury.
Before trimming, bring engine to a
speed sufficient to cut material to be
trimmed.
Do not run the engine at a higher speed
than necessary. The cutting line will cut
efficiently when the engine is run at less
than full throttle. At lower speeds, there
is less engine noise and vibration.
Always
release the throttle trigger and
allow the engine to return to idle
speed when not cutting.
HOW TO STOP YOUR UNIT
• Release the throttle trigger.
• Push and release the engine ON/
STOP switch.
CUTTING
METHODS
4(_WARNING:
Use minimum
speed and do not crowd the line when
cutting around hard objects
(rock,
gravel, fence posts, etc.), which can
damage
the trimmer head, become
entangled
in the line, or be thrown
causing
a serious hazard.
• The tip of the line does the cutting.
You will achieve the best perform-
ance and minimum
line wear by not
crowding the line into the cutting
area. The right and wrong ways are
shown below.
Tip of line does the
Line crowded into
cutting,
worl
Right
Wrong
• The line will easily remove grass
and weeds from around walls,
fences, trees and flower beds, but it
also can cut the tender bark of trees
or shrubs and scar fences.
• For trimming or scalping,
use less
than full throttle to increase
line life
and decrease
head wear, especially:
• During light duty cutting.
• Near objects around which the line
can wrap such as small posts,
trees or fence wire.
TRIMMING
- Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low only the tip of the line to make
contact
with vegetation.
Do not force
trimmer line into work area.
14
Publicidad
