Publicidad
PREPARATION
UNPACKING
INSTRUCTIONS
The mower was fully assembled at the factory. When the mower
was put in the carton, the handle was put in a folded position (see
Figure 1). To put the handle in the operating position, follow the
steps below.
Handle
1.
Remove the packing material from the carton.
2.
Remove the side discharge attachment, the oil, and the fuel
stabilizer from the carton. Put the fuel stabilizer in a safe
place until needed for storage.
3.
Cut down all four corners of the carton.
CAUTION: Be careful when you fold or raise the handle. Do
not damage the cables. A cable that is bent will not work
correctly. Before you use the unit, replace a bent or dam-
aged cable.
4.
Raise the upper handle and the lower handle to the operat-
ing position (see Figure 2). Tighten the knobs that secure
the upper handle to the lower handle.
RecoiI-Sta
J
Rope Guide
Knob
Folded Position
Side Discharge Attachment
Figure 1
Blade Rotation
Control
Upper Handle
Knob
Lower Handle
J
Adjuster Arm
Adjuster Arm
Figure 2
5.
Each adjuster arm has three mounting holes. These
mounting holes will raise the height of the handle approxi-
mately four inches. Determine the desired height and mount
the adjuster
arms to the lower handle (see Figure 3).
6.
Tighten the knobs that secure the lower handle to the han-
dle brackets.
7.
To attach the recoil-start
grip to the rope guide, twist the
rope through the rope guide mounted on the right side of the
handle (Figure 2).
Adjuster Arm
Lower Handle
Handle Brack_
Knob
Figure 3
F-020433M
6
Publicidad
