nedis TVRC40LGBK Manual Del Usuario

TVRC40LGBK
Remote control
Description
1. On/off button
2. TV button
3. Satellite button
4. Previous program button
5. Next program button
6. Volume - button
7. Volume + button
8. OK button
9. Mute button
10. Learn button
11. Digit buttons
12. LED indicator
Use
Programming the remote control to the TV or another device
1. Switch on the device to be programmed.
2. Look for the brand of the TV that you want to program in the code list. Make a note of the first code in the list.
3. Press and hold the TV or satellite button of the remote control until the LED indicator comes on.
4. Enter the previously identified code.
Note: If the LED indicator goes off, it indicates that the code is accepted. If it switches on or off the TV, it indicates that the code is
correct. If it does not switch on or off the TV, repeat from step 2 to try another code.
Auto search
1. Switch on the device to be programmed.
2. Press and hold the TV and satellite buttons simultaneously until the LED indicator comes on.
3. Point the remote control to the device. Press and slowly release the on/off button.
Note: If the device is switched off, it indicates that the code is found.
12
2
1
11
4
7
0
LEARN
4
6
VOL-
8
• Press the button to switch the TV on or off.
• Press this button to control the TV.
• Press this button to control the set-top-box or
other programmed devices.
• Press the buttons to navigate through the
programs.
• Press the button to increase or decrease the
volume.
• Press the button to confirm a selection.
• Press the button to mute the sound..
• In learn mode, press the button to activate the
signal before copying functions from other
remote controls.
• Press the buttons to select the channel.
• The LED indicator shows the status of the device.
3
T V SAT
2 3
5 6
8 9
9
0
7
OK
VOL+
5
P-
English