Publicidad
Idiomas disponibles
Idiomas disponibles
Although this appliance automatically
defrosts, a layer of frost may occur on
the freezer compartment's interior walls if
the freezer door is opened frequently or
kept open too long. If the frost is too
thick, choose a time when the freezer is
nearly empty and proceed as follows:
1.
Remove existing food and accessory
baskets, unplug the appliance from
the main power and leave the doors
open. Ventilate the room thoroughly to
accelerate the process.
2.
When defrosting is completed, clean
your freezer as described above.
WARNING!
Do not use sharp objects to remove
frost from the freezer compartment.
Only after the interior is completely
dry should the appliance be
switched back on and plugged
back into the main socket.
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash seal with a
mild detergent and warm water. Rinse
and dry it thoroughly after cleaning.
CAUTION!
Only after the door seals are
completely dry should the
appliance be powered on.
Replacing the LED light
WARNING!
The LED light must be replaced
by a competent person. If the
LED light is damaged, follow the
steps below：
1. Unplug your appliance.
2. Remove the light cover by
lifting up and pulling out.
3. Hold the LED light with one
hand and pull it while pressing
the connector latch with the
other hand.
4. Replace the LED light and
snap it correctly in place and
replace the light cover.
18
Publicidad
