Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Battery test
When the tester detects that the surface charge has been eliminated, switch off the lights as prompted
and then press ENTER. The tester will restore the automatic test.
Battery selection for car / scooter
Once the battery test has been selected, the tester will prompt you to select the batteries for your car /
scooter. Press the UP/DOWN button to select Car / Scooter and then press the ENTER button to confirm.
Battery type selection
After selecting Car / Scooter, the tester will prompt you to select the battery type, i.e. Regular flooded,
lithium-ion, AGM Flat Plate or AGM Spiral, gel and EFB. Press the UP/DOWN button to select the battery
type and then press the ENTER button to confirm.
Note: Lithium-ion battery is only found in scooter battery types, not car batteries.
Battery system standard and rating
The battery tester will test each battery according to the selected system and rating.
Use the UP/DOWN button to select according to the current system standard and rating marked on the
battery. In the figure below, the arrow indicates the location.
CCA: Cold Cranking Amps, specified by SAE&BCI, most frequently used value for starting battery at 0°F (-
18°C).
BCI: Battery Council International standard
CA: Cranking Amps standard, effective starting current value at 0°C
MCA: Marine Cranking Amps standard, effective starting current value at 0°C.
JIS: Japan Industrial Standard, displayed on the battery as combination of the numbers and letters, e.g.
55D23,80D26.
DIN: German Auto Industry Committee Standard
IEC: Internal Electro technical Commission Standard
EN: European Automobile Industry Association Standard
SAE: Society of Automotive Engineers Standard
GB: China National Standard
Publicidad
