MSW Motor Technics MSW-BLT-2 Manual De Instrucciones página 21

OR
Start engine -> RPM Detected -> REPLACE -> Cranking Normal
Charging Test (Alternator Test)
Tester prompts as following:
Select "Charge test" and press the Enter key to start the charge test.
Note: Do not switch off the engine during the test. Follow the steps in the instructions below.
Once the test is complete, the tester will display the charging voltage at load and no load, the ripple
voltage and the result of the charging test.
Note: "NO OUTPUT" means the charging system is not working. The vehicle will stop working when the
battery runs out. Check the alternator or contact a service center immediately.
EN
Ripple Test
Turn off headlights and air
conditioning, keep for 10
seconds
Press ENTER to continue
Unloaded Test
Turn off all devices, increase
RPM to 2500-3000r/min and
keep for 10 seconds
Press ENTER to continue
Loaded Test
Turn on headlights and air
conditioning to the max flow,
keep RPM idle for 10 seconds
Press ENTER to continue