and the Wi-Fi lamp turns off.
4.4 EMPTYING
Manual emptying:
Emptying the water tank by hand.
Continuous emptying:
Draining the condensation water by attaching a drain hose.
4.4.1 MANUAL EMPTYING
The water tank built into the unit fills up and switches the unit off as soon as it is full. The unit will
continue to run once you have emptied the water tank and reinstalled it correctly.
When the tank is full, the unit emits a buzzing sound and the "water full" light comes on.
Touch the POWER button to switch off the unit.
Pull the water tank and remove it from the dehumidifier housing.
Empty the tank.
Clean the inside and outside of the tank if necessary.
Put the empty tank back into the unit.
Press the POWER button to resume operation.
If the "water full" light does not go out, check that the tank is inserted correctly.
4.4.2 CONTINUOUS EMPTYING
For continuous operation or unattended dehumidification, please connect the enclosed drain hose
to the unit. The condensation water can drain off automatically.
Place the unit on a horizontal surface and in a stable position.
Switch off the unit before operating.
Connect the drain hose securely and properly and make sure it is not kinked and free from
obstructions.
Place the outlet of the hose over a drain or bucket so that the water can flow freely. The hose
must not be under water, otherwise the water cannot drain away unhindered
To avoid spilling water, tilt the drain hose down towards the floor. The slope should be more
than 20 degrees.
30
www.DEUBAXXL.de