Rehan i-See HD Manual De Instrucciones página 15

3 Safety
• Avoid direct sunlight on the screen and tableau of the i-See HD.
• Be careful when handling the moving parts of the reading table of the i-See HD.
• The i-See HD requires little or no maintenance. If you want to clean the exterior of the
device, only use a dry cloth. The use of aggressive cleaning products like alcohol,
acetone or other chemical substances is prohibited.
• Do not use the i-See HD as a support for walking, sitting down or getting up.
• Switch off the i-See HD if you do not intend to use it.
• Ensure that the i-See HD is placed in a well ventilated room.
• Place the i-See HD on a stable and horizontal surface to prevent it from falling.
• Ensure that the i-See HD is placed at least 10 cm / 4 inches from the edge of the table.
• Only use the i-See HD indoors. Do not expose the i-See HD to extreme temperature
fluctuations or humidity. Do not place the i-See HD next to a heat source or in direct
sunlight.
• Only use the supplied cables and connect the power cable to an earthed socket
• Use of this equipment adjacent to or stacked with other equipment should be avoided
because it could result in improper operation.
• Use of accessories, transducers and cables other than those specified or provided by
the manufacturer of this equipment could result in increased electromagnetic emissions
or decreased electromagnetic immunity and result in improper operation.
• Portable RF communications equipment (including peripherals such as antenna cables
and external antennas) should be used no closer than 30 cm (12 inches) to any part of
the i-See HD, including cables specified by the manufacturer. Otherwise, degradation of
the performance of this equipment could result.
3.1 Transporting the i-See HD
If the device needs to be transported it is advised to transport it in its original packaging
in order to avoid any potential injury or damage to the device. Keep the transport and
storage temperature conditions in mind.
4 Installation
The i-See HD will be delivered to you in a pre-assembled state. All you have to do is
connect the TFT monitor to the base, attach the cables to the control interface and TFT
monitor and connect the power cable to the base.
4.1 Attach TFT screen
You can attach the TFT monitor by hanging it on the base and tightening the bolts on
both rear sides of the screen.
i-See HD
EN
.
15