Publicidad
Idiomas disponibles
Idiomas disponibles
Device-specific additional instructions for nailer
4
Filling the magazine
Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position
•
(Chap. 3): The driving nose must point away from any
person. It must be impossible to unintendly actuate trigger
and/or release protection.
Press the latch button 1 and push the magazine cover 2 to
•
the rear. Insert the round head nails with the tips at the
bottom into the magazine 3. Then push the magazine cover
2 forward
.
5
Adjusting drive-in depth
Reduce pneumatic operating pressure as far as possible to
•
minimize blowback, noise and air consumption (see General
operating instructions).
Mechanical adjustment of drive-in depth:
Disconnect the tool from the compressed air supply. Turn
•
adjustment knob 1 for deeper countersunk nails clockwise. Turn
anti-clockwise to lower the nails less deeply.
6
Removing stuck fasteners from the driving channel
Disconnect the tool from the compressed air supply. Open the magazine as described in chapter 4 and
•
remove the brads. Then reconnect the tool to the compressed air supply and refill it with brads
7
EU Declaration of conformity
Friedrich
The Joh.
Behrens AG, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's
conformity with all relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
-------------------------------------------------
Tobias Fischer-Zernin, Management
All manuals and user guides at all-guides.com
SK355-214E
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7
.
Publicidad
