Publicidad
Idiomas disponibles
Idiomas disponibles
DRIVECONTROL
o Self-propelling is controlledby holding
the operatorpresencecontrolbar down
to the handleandpushingthe drive
controlleverforwarduntil
it clicks; then
release the lever.
o Forward motion will stop when the
operator
presence
control bar is
released.
To stop forward
motion
without stopping
engine, release the
operator
presence
control bar slightly
until the drive control disengages.
Hold
operator
presence
control bar down to
handle to continue
mowing without self-
propeiting,
° To keep drive control engaged when
turning comers,
push down on handle
and lift front wheels off ground While
turning lawn mower.
Operator presence control bar
Drive
To engage drive
control
Ddve cont_l
desengaged
BEFORE
STARTING
ENGINE
OIL
Your lawn mower Is shipped without oil in the
engine,
* Be sure moweris level and area around oil
fill is clean.
o Remove engine oil cap w/dipstick and fill to
the full line on the dipstick.
o Use 27 ozs. of oil. For type and grade of oil
to use, see "ENGINE" in Customer
Responsibilities section of thi._manual.
o Pour oil slowly, Do not over fill.
= Check oil level before each use. Add oil if
needed, Fill to full line on dipstick,
. To read proper level, tighten engine oil cap
each time,
. Reinstall engine oil cap and tighten.
o Change the oil after every 25 hours of
operation oreach season. You may need
to change the oil more often under dusty,
dirty conditions,
ADD GASOUNE
,, Fill fuel tank, Use fresh, clean, regular
unleaded gasoline with a minimum of 87
octane. Do not mix oil with gasoline.
Purchase fuel in quantities that can be used
within 30 days to assure fuel freshness,
IMPORTANT_ When operating in
temperatures below 32°F(0°C), use fresh,
clean winter grade gasoflne to help insure
good cold weather starting,
WARNING:
Experience indicates that alcohol
blended fuels (called gasohol or using ethanol
or methan01) can attract moisture which leads
to separation and formation of acids dudng
storage. Acidic gas can damage the fuel
system of an engine while in storage. ]b avoid
engine problems, the fuel system should be
emptied before storage of 30 days or longer.
Drain the gas tank, start the engine and let it
run until the fuel lines and carburetor are
empty. Use fresh fuel next season.
See
Storage Instructions for additional information.
Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur,
CAUTION:
RII to bottom of gas tank filler
neck. Do not overfill. Wipe off any spilled oil
or fuel, Do not store, spill or use gasoline near
an open flame.
filler cap
Entine oil cap w/
dipstick
TO START ENGINE
• To start a cold engine, push prfmer five (5)
times before trying to start. Use a fin'n push.
]his step is not usually necessary when
starting an engine which has already run for
a few minutes.
• Hold operator presence control bar down to
the handle and pull starter handle quicldy.
Do not allow starter rope to snap back.
o To stop engine, release operator presence
control bar.
8
Publicidad
