Publicidad
Idiomas disponibles
Idiomas disponibles
ELE-105
Polarized electrical undergrounded outlet
Important
If you are not sure about some instruction, consult a qualified electrician.
To avoid an electric shock, fire or death, stop the passage of energy through the circuit breaker or fuse. Make sure the circuit is not powered
before starting the installation!.
Installation
1. Screw the base to the wall box
using the provided screws.
Cable diagram
Specifications
125/220V ~ 10A
ELE-105
Polarized electrical undergrounded outlet
This Steren product is warranted under normal usage against defects in workmanship and materials to the original purchaser for
one year from the date of purchase.
1.- This warranty card with all the required information, invoice or purchase ticket, product box or package, and product, must be
presented when warranty service is required.
2.- If the product stills on the warranty time, the company will repair it free of charge.
3.- The repairing time will not exceed 30 natural days, from the day the claim was received.
4.- Steren sell parts, components, consumables and accessories to customer, as well as warranty service, at any of the addresses
mentioned later.
If the product has been damaged by an accident, acts of God, mishandling, leaky batteries, failure to follow enclosed instructions,
improper repair by unauthorized personnel, improper safe keeping, among others.
a) The consumer can also claim the warranty service in the purchase establishment.
b) If you lose the warranty card, we can reissue it, if you show the invoice or purchase ticket.
In case your product fails or have questions, please contact your nearest dealer.
Instruction manual
Before making the installation read this manual to prevent any damage.
2. Peel 1 cm of the end of
each conductor.
3. Connect the conductor in
its place according to the
cable diagram.
4. Secure the screw tightly.
THIS WARRANTY IS VOID IN THE NEXT CASES:
If you are in Mexico, please give a call to our Call Center.
Call Center 01 800 500 9000
5. Insert the module, by pressure in
front to the support.
Warranty
CONDITIONS
6. Assemble the new plaque, by
pressure, to the support.
7. Re-establish the power or fuse.
Publicidad
