Descargar Imprimir esta página

Beper T041 Manual Del Usuario página 15

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
EN
Time and date setting
With the appliance powered off , but with batteries installed, press
button 3 seconds. Set
the month first by adjusting the "M " button. Press
button again to confirm current month.
Continue setting the day, hour, and minute with the same method.
Every time the
button is pressed, it will lock in your selection and continue in succession
(month, day, hour, minute.)
To save settings:
While in any setting mode, press
button about 3seconds to turn the unit off.
All information will be saved.
Note: Unit will automatically save all information and shut off if left it for 3 minutes.
Use
Install batteries by sliding battery cover off as indicated by arrow, install two AAA batteries
according to polarity, close battery cover. Fig. C
Free the wrist from any clothing. Do not apply the appliance over clothing. Fig. D
Apply the cuff to the left wrist and hold it at the same level as the heart level. Place it about
1-2 cm from your wrist. Fig. E
Note: Pressurization will gradually subside and ultimately stop when cuff is not properly
applied to the wrist.
If this occurs, pressing the
button to turn the unit off.
Safety Precaution: If pressure in cuff becomes too extreme while testing, press the " "
button to turn power off.
The cuff pressure will rapidly dissipate once the unit is off.
To stat the testing, press and hold " " button until a beep sounds. Fig. F. On the LCD display
will appear for one second as unit performs a quick diagnosis.
Note: Unit will not function if residual air from previous testing is present in cuff.
On the display will flash an arrow until pressure is stabilized.
15

Publicidad

loading

Este manual también es adecuado para:

40.121