Lifegoods LG551 Manual De Instrucciones página 16

3.1. Set up
1. Place the product in the center of where you want to set it up. Remove the product from the
carrying case and set the product upright on its legs.
2. Grasp two opposite legs together, lift the frame slightly off the ground and take small steps
backwards, stopping at full (extended) arm's length. Be careful not to unfold the tent too
quickly, this may cause the legs to bend.
3. Close the slider at each corner by pushing the top of the leg up with one hand while holding
the top of the leg with the other. A button will snap into the mounting hole. Repeat this
operation on the remaining three legs. Be careful not to pinch your fingers or pull back too
hard, as this will cause the side supports to bend.
4. Firmly place the legs of the product. You can adjust the height by choosing one of the three
holes. Attach the Velcro at the bottom of the cloth to the frame supports.
5. Pull the cloth down at the corners and secure it with the hook at the end. Repeat for all the
corners.
6. Thread the guy lines through each corner of the canvas. Use the guy lines and pegs to
anchor the product to the ground.
1.
4.
16
2.
5.
3.
6.