GE AGM06 Manual De Instrucciones página 4

About the controlson the air conditionermmodels with touchpads.
Features and appearance will vary.
Cool on -
Fan on
Energy
Saveror
Energy
Saveron
on
Cool on 0
0
@
FAN SPEED
<22_ O
TIMER MODE
@
Air ConditionerControls
Remote Control
Controls
O ON/OFF Pad
TtlFIIS air Coilditioiler
Oil _lIld ()_.
Oisplav
Shows the set temperature or time remaining
011 tillleE
O MODE
Use to set the air conditioner
to COOLor
FAN inode.
Increase •/Decrease • Pads
Use to set temperature when in COOLmode.
O FAN Pad
Lrse to set the tim speed to LOW(FI), MED (F2)
or HIGH (F3).
O ENERGYSAVER
(on some models)
Controls the tim.
0N--The tim and compressor cycle on and
off'. This results in wider \m_iations of room
temperature and humidity. Nommllv used
when tile room is unoccupied.
NOTE." T hefan
will continue to run for a short time after the
compressorcyclesoff.
OFF--The tan rtms all the time, while the
compressor cycles on and off.
This ti_ature must be set at OFFin order to
use the em settings (on the mode control).
NOTE."Onsome models, the ENERGY SAVERfeature
cannot be set on the air conditioner /t must be set using
the remote control.
e CIRCULAIRE (on some models)
For ('Olltillt/OtlS side-to-side air (-irculadon
(cool settings only), set the Circulaire switch
to ON.
For fixed side-to-side air direction, mrn
ON
tmtil the desired air direction is obt;fined,
then turn it OFF.
O TIMER Pad
ON--_hen the air conditioner is off, it can be
set to automatically come on in 1 to 12 hom_
or 1 to 24 hom_
(depending
on model)
at its
previous setting. Each touch
of the TIMER pad
or the INCREASE •/DECREASE• pads
(depending on model) will set the timer
in hom_.
OFFi\,_]len the air conditioner is on, it can be
set to automatically mrn off in 1 to 19 h om_ or
1 to 24 hom_ (depending on model). Each
touch of the TIMER pad or the INCREASE• /
DECREASE• pads (depending on model)
will
set the timer in hom_.
Tocancel the timer, press the TIMER pad tmfil
the display time disappears.
O Remote Control Signal Receiver
4
Remote Control
To ensm'e proper operation, aim the remote
control at tile signal receiver
on the air
Collditiollei:
The remote control signal has a range of
up to 21 feet.
Make sure nothing is between the air conditioner
and the remote control that could block the
signal,
Make sure batteries are fl'esh and installed
correctly as indicated on the remote control,