GE AGM06 Manual De Instrucciones página 5

GEAppliances.com
Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
COOLMode
Use tile COOL Inode with HIGH(F3),MED (F2)or
LOW(FI) tm_for cooling. Use the INCREASEA/
DECREASEVpads to set the desired temperature
between 60°F and 86°F in 1°F increments.
An electronic them/ostat is used to maintain tile
room temperature, The compressor will cyde on
and off to keep the room at file set level of comfi)_t.
Set file thelinostat at a lower ntunber and file indoor
air will be(xm_e coole_: Set the them_ostat at a higher
number and tile indoor air will become _a;mne_:
NOTE" If theair conditioner i soff andis thenturned on
whileset to COOL, it will takeapproxlknate/y 3 mbutes
forthecompressor tostartandcoo/ing to beglb.
CoolingDescriptions
ForNormalCooling--Selectthe COOL mode and
HIGH(F3)or MED (F2)tim with a middle set
temperature.
ForMaximumCooling---Select tile COOL mode
and HIGH(F3)tim with a lower set temperature.
ForQuieter& Nighttime
Cooliug---Select
tile
COOLmode and LOW (FI)tim with a middle set
temperature.
NOTE: If youswitchfroma COOL settingto OFF or to a fan
setting,wait at least3 minutesbeforeswitchlbg backtoa
COOL setting.
FAN Mode
Use the FAN at HIGH
(1:3), MED (F2)or LOW(FI)
to Since tim only settings do not provide cooling,
provide air circulation and filtering without cooling, a temperature setting will not be displayed.
Power Outage Recovery Feature
In tile case el a power outage or interruption, tile
unit will automatically re-start in the settings last
used atter tile power is restored.
Tile TIMERleature
will reset to tile original setting. Y)m may need to set
a new time if desired.
Vent Control
Tile vent control is located above tile control
panels.
When set at CLOSE, only tile air inside tile room
will be circulated and conditioned. _4'hen set at
OPEN,
s ome inside air is exhausted outside.
To open the vent, pull the lever toward you.
To close it, push it hT.
Air Direction--Side-to-Side
Tile side-to-side air direction is ac!j usted by moving
tile lever
to tile lett or fight.
Air Direction--Up and Down
Fingertip pressure on tile horizontal lou\'e_
at!justs tile air direction up or down.
(on some models)
5