Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
WARNING:
other parts may create a hazard or cause product damage . To ensure safety and
reliability, all repairs should be performed by a qualified service technician .
WARNING:
from the product when cleaning or performing any maintenance .
CLEANING
Use a soft brush to remove debris from all air intakes and cutting blade .
To remove pitch and other sticky residue, spray the blades with resin solvent . Run
the motor briefly so that the solvent is event distributed, then wipe the surface
with a dry cloth .
WARNING:
when cleaning plastic parts . Most plastics are susceptible to damage from various
types of commercial solvents . Use clean cloths to remove dirt, dust, oil, grease, etc .
SHARPENING THE CUTTING
BLADE
1 . Start and stop your hedge trimmer
until the cutter blade and the guard are
slightly offset, as shown in Fig . 7 . This
will allow clearance for the file between
cutter teeth and guard teeth .
2 . Remove the battery pack from your
hedge trimmer .
3 . Clamp the blade assembly in a vise and file the exposed cutting surface of each
blade tooth . Remove as little material as possible . Be sure to retain the original angle
of each tooth when filing .
4 . Remove the hedge trimmer from the vise; reinstall the battery, restart it and then
stop it to expose the unsharpened edges of the blade teeth .
5 . Remove the battery pack and repeat the sharpening procedure above .
24
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2600/HT2600-FC
When servicing, only use identical replacement parts . Use of any
To avoid serious personal injury, always remove the battery pack
Never use water for cleaning your trimmer . Avoid using solvents
7
Cutter Tooth
Cutting Surface
Guard Tooth
Publicidad
