IMPORTANT: these instructions are for your safety.
GB
Read them carefully before use and keep them
for future use.
• Children should be supervised to ensure they do not play with the device.
• Shut off the power at your electrical board.
• Do not use this detector outside of the home or in a humid atmosphere.
• Always check that the power of the device to be connected to the detector does
not exceed authorised power.
• This fixture is not designed to be used by people (including children) with re-
duced physical, sensory, or mental capacities, or by people lacking experience or
knowledge, unless they are supervised by someone who is responsible for their
safety, or are provided with instructions concerning its use.
• If you have any concerns or problems, consult an electrician or another qualified
person. All the instructions for our products may be downloaded from our web-
site at www.tibelec.fr.
This detector enables you to install a toggle switch without using any cables or
drilling holes in the walls! The module is installed behind an existing single light
switch and the infrared detector is installed on the wall or ceiling, within 70 metres
to ensure the wireless toggle functions.
Thanks to this infrared motion detection system, you can automatically light up a pas-
sageway: driveway, garden, etc. Motion in front of the infrared sensor triggers any de-
vice connected to it. If it is a lighting device, it will light up instantly and remain lit as
long as the protected area is occupied. This detector uses the most advanced passive
infrared technology, detecting moving heat sources such as human beings, animals and
cars, for a distance up to approximately 8 metres. Works through partition walls. The
transmission between the module and the infrared switch takes place via radio waves.
8