GE 16 Manual Del Propietario E Instalación página 3

IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
AWARNING!
HOW TO CONNECTELECTRICITY
GEAppliances.com
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this appliance must be properly grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong (grounding) wall outlet to minimize the
possibility of electric shock hazard from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded.
Where a standard 2-prong wall outlet is encountered, it
is your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
The refrigerator should always be plugged into its own
individual electrical outlet which has a voltage, wattage
and frequency that match the rating plate.
This provides the best performance and also prevents
overloading house wiring circuits which could cause a
fire hazard from overheated wires.
Never unplug your refrigerator by pulling on the power
cord. Always grip plug firmly and pull straight out from
the outlet.
Repair or replace immediately all power cords that have
become frayed or otherwise damaged. Do not use a
cord that shows cracks or abrasion damage along its
length or at either end.
When moving the refrigerator away from the wall, be
careful not to roll over or damage the power cord.
USE OF EXTENSION CORDS
Because of potential safety hazards under certain conditions, we strongly recommend against the use of
an extension cord.
However, if you must use an extension cord, it is absolutely necessary that it be a UL-listed (in the United States)or
a CSA-listed(in Canada), 3-wire grounding type appliance extension cord having a grounding type plug and outlet
and that the electrical rating of the cord be 15 amperes (minimum) and 120 volts.
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
SAVE THESE INSTRUCTIONS
About Energy S
mart T" Models
What Energy Smart
TM
Does
If the ACM (Appliance Communication
Module) is connected to your refrigerator
and is receiving utility rate information,
then the Energy Smart
TM
feature alters the
performance of the refrigerator. It minimizes
energy consumption when directed by the
Energy SmortTM Switch
Models with the EnergySmart TM feature
have an additional button and LEDlight on
the controls as shown. The LEDwill be ON
during high rate periods and OFF during low
Nucleus (sold separately) or Smart Meter. This
feature can cause changes in the refrigerator
or freezer compartment temperatures
and can cause changes in rate of ice cube
production.
or normal rate periods. The button is used
to disable the EnergySmart TM feature (see
"EnergySmart TMoverride" section).
Energy Smart TMOverride
Press and hold the Energy Smart
TM
button
for 3 seconds to override the Energy Smart
TM
feature. The adjacent LEDwill flash three
times to confirm a successful override of the
feature. This will prevent the feature from
altering the performance of your refrigerator
for 18 hours. During this 18 hour period, the
LEDwill remain OFF.Eighteen hours after
the feature has been disabled, the Energy
Smart
TM
feature will return to its normal
operating routine.