Phrase Loop Play; Checking The Values Of Controls; Making The Settings For Control Operation - Boss ME-25 Manual De Instrucciones

Convenient Functions

Phrase Loop Play

You can record up to 38 seconds of a performance and play back
the recorded section over and over. You can also layer additional
performances with the recording as it plays back (overdubbing).
This lets you create realtime backing performances on the fly.
1.
Press & hold
> 2sec
STANDBY
5.
OVERDUB
SOLO Pedal
Indicator
Lit
Off

Checking the Values of Controls

Operations such as calling up memories or Sound Library sounds
may result in discrepancies between the stored parameters and the
actual positions of the controls.
You can get the actual parameter values to appear in the display so
you can check them.
Hold down [EXIT] and turn the control for the
value you want to check.
The value of the knob appears on the display for several seconds.
10
2.
REC
5.
3.
4.
PLAY
4.
1.
Hold down the SOLO pedal for two seconds or
longer (STANDBY).
Phrase Loop goes into recording standby and the SOLO
pedal's indicator flashes at a fixed interval.
2.
Press the SOLO pedal (REC).
Recording starts as soon as you press the SOLO pedal, and the
SOLO pedal's indicator flashes rapidly.
3.
Press the SOLO pedal again (PLAY).
Recording ends. As soon as recording stops, repeated
playback of what you've recorded starts, and the SOLO pedal's
indicator lights continuously.
An oscillating sound may be audible when the recording time is
extremely short.
4.
To layer additional recordings (overdubbing),
repeat Steps 2 and 3 (OVERDUB).
You can switch memories even during phrase loop play, which lets
you record a variety of overdubbed sounds.
5.
To stop loop playback, press the SOLO pedal
twice in quick succession (STANDBY).
Loop playback/recording stops, and Phrase Loop returns to
recording standby.

Press the pedal twice within the span of one second.

When playback ends, the recorded data is deleted.
6.
Hold down the SOLO pedal for 2 seconds or
longer.
This exits Phrase Loop mode.
Making the Settings for
Control Operation
When you call up memories, an effect's parameters may not reflect
the actual position of the control knobs. You can set how the
parameters behave when the control knobs are moved in this state.
1.
Hold down [EXIT] and press the MEMORY
pedal.
2.
Use MEMORY
method of control operation.
Display Control operation
n0 The value changes immediately as the knob is turned
(factory setting).
n1 The value changes once the knob is turned past the posi-
tion corresponding to the currently set value.
3.
Press [WRITE].
The setting is stored in memory.
/ pedals to select the