Publicidad
Idiomas disponibles
Idiomas disponibles
REFRIGERATOR
SHELVES
The shelves in your refrigerator are adjustable to meet
your individual storage needs. Your model may have
glass or wire shelves.
Storing similar food items together in your refrigerator and
adjusting the shelves to fit different heights of items will
make finding the exact item you want easier; it will also
reduce the amount of time the refrigerator door is open,
saving energy.
IMPORTANT: Do not clean glass shelves with warm
water when they are cold. Shelves may break if exposed
to sudden temperature changes or impact, such as
bumping. For your protection, glass shelves are made
with tempered glass, which will shatter into small pebble-
sized pieces.
NOTE: Glass shelves are heavy. Use special care when
removing them to avoid dropping them.
Adjusting
Shelves
Remove shelves from the shipping position and replace
shelves in the position you want.
• To remove a shelf--Tilt
up the front of the shelf in the
direction of (1) and lift it in the direction of (2). Pull the
shelf out.
_, CAUTION: Make sure that shelves are level from one
side to the other. Failure to do so may result in the
shelf falling or spilling food.
Sliding Out Shelves
You can slide glass shelves in and out of your refrigerator
as follows.
• To slide the shelf out, carefully pull front of shelf
toward you.
• To slide shelf in, push shelf in until it stops.
BOTTLE
HOLDER
(795.7757*
Model Only)
Bottles can be stored laterally with this bottle holder. It
can be attached to any shelf.
• To reinstall a shelf--Tilt the front of the shelf up and
guide the shelf hooks into the slots at a desired height.
Then lower the front of the shelf so that the hooks drop
into the slots.
, ¢
Bottle holder can be removed by pulling it straight out and
installed by placing it at the end of the shelf you want and
pushing it inward.
21
Publicidad
