Descargar Imprimir esta página

Flama 2362FL Manual De Instrucciones página 18

Publicidad

Idiomas disponibles

Idiomas disponibles

Turn the power selector to the desired
position according to the heat required:
• - Low heat
•• - Medium heat
••• - High heat
Turn the thermostat regulator clockwise
until it stops (MAX); the indicator light turns
on.
When the room temperature has risen
to a comfortable level, slowly turn the
thermostat regulator anti-clockwise until
the indicator light goes out.
To adjust the room temperature, turn the
thermostat regulator clockwise to increase
the temperature or anti-clockwise to
decrease it. Thus, the radiator will try to
maintain the ambient temperature at the
desired level.
Turning off the radiator
To turn off the radiator, turn the thermostat
control knob counterclockwise to the MIN
position and the power level selector to the
0 position. The lighted indicator will turn
off.
Unplug the radiator from the power supply
and let cool.
NOTE: The lighted indicator will remain
on only if the temperature is lower than
the one established on the thermostat
and means that the radiator is heating the
room.
16
Tip-over protection
This radiator is protected with a safety
switch that will automatically turn off the
appliance when it falls over or is placed at
an excessively horizontal angle. This helps
prevent accidents. The radiator will resume
operation when returned to a vertical
position.
Overheating protection
This radiator is equipped with overheating
protection that will automatically turn
off the appliance in the event of severe
overheating.
If this should occur, unplug the appliance,
wait for around 30 minutes until it
cools and remove any possible cause of
overheating, such as something covering
the radiator. Check for any damage to the
appliance, power cord and plug. If there are
no damages, plug it in again and turn it on
as described above. If the radiator still does
not turn on, contact a technical assistance
service.
www.flama.pt

Publicidad

loading