JBM AET-R1B1 Manual De Instrucciones página 12

EXPLANATION OF MARKS OR SYMBOLS
The following symbols may appear on the manual,
Infrared Thermometer and its accessories.
MUST OBSERVE
Means Obligatory with detailed items
expressed in words or figures within or
beside the mark. Left one means General
Compulsory.
Follow instructions for use.
IMPLICATION OF SYMBOL
Type-BF applied part.
Caution: Consult accompanying
documents.
Do not dispose this product as unsorted
municipal waste. Collection of such waste
separately for special treatment is
necessary.
Transport package shall be kept away from
rain.
Transport package shall not be exposed to
sunlight.
Indicates correct upright position of the
transport package.
Contents of the transport package are
fragile therefore it shaII be handled with
care.
Indicates temperature limits within the
transport package shall be stored and
handled.
Non-ionizing electromagnetic radiation.
Do not roll.
Lot number.
Production date.
The device should not be used after the
end of the shown or the day.
Protected against solid foreign objects of
12.5mm dianeter and greater. protected
against vertically falling water drops when
the device is tilted up to 15°.
Manufacturer.
CE Mark: conforms to essential
requirements of the Medical Device
Directive 93/42/EEC.
Authorized Representative in the European
Community.
MAINTENANCE, STORAGE AND CALIBRATION
Maintenance
1. Remove any stains on the body with a soft and dry
cloth.
2. Clean the probe tip as follows: very gently wipe the
surface with a cotton swab or soft cloth moistened with
clinical alcohol, after the alcohol has completely dried
out, you can use the thermometer. If the probe tip is
damaged, please contact the maintenance center.
3. Don't wash with water or detergent containing
abrasive or benzene.
4. Do not immerse in liquids.
Storage
1. The device must not be stored or used at an excessi-
vely high or low temperature or humidity, in sunlight, in
association with un electrical current or in dusty
locations.
2. Remove the battery if non-use for a long time.
Calibration
This thermometer is calibrated at the time of manufac-
tured. If the thermometer is used according to the
instruction, periodic recalibration is not required. If at
any time you question the accuracy of the measure-
ment, contact the retailer immediately. Don't attempt to
modify or reassemble the thermometer.
WARRANTY
1 year warranty from the date of purchase, excluding
errors made by the user below:
1. Error produced by unauthorized disassembly and
modification.
2. Error produced by a fall during use or transport.
3. Error produced by use far from the instructions
described in the manual.
INCLUDED IN DELIVERY
• Infrared thermometer
• Manual
STANDARD
This product is made under the ISO80601-2-56.
11
REF. 53794