Musway SUB1 Manual De Uso página 11

VARIABLE BASS BOOST
By using the BASS BOOST controller [ 10 ] you are able to increase the bass enhancement from 0 to 12 dB.
ATTENTION: Use the BASS BOOST wisely!
PHASE SWITCH
The PHASE switch [ 11 ] allows to switch the phase from 0° to 180° to match the output signal with the vehicle's
interior acoustic.
VARIABLE LOW PASS FILTER
Set the desired crossover frequency by using the controller LOW PASS [ 12 ]. Thus to that only the frequencies
below the chosen crossover frequency will be amplified and the subwoofer plays more precisely and efficient.
BASS LEVEL REMOTE CONTROLLER
With the included bass level cable remote controller [ 13 ] allows to adjust the bass level e.g. out of the driver's
seat. Connect the remote controller and the REMOTE CONTROL terminal [ 14 ] with the enclosed cable.
13
PROTECTION CIRCUIT
The PROTECT LED [ 15 ] lights up red, when the amplifier is overheated, or a short circuit occurs respective
a too low impedance load is connected to the speaker outputs. If this events, the internal built-in protection
circuit shuts down the amplifier automatically. The amplifier should work again properly after you have solved
the problems.
The POWER LED [ 16 ] lights up green, if the amplifier is in operation.
10
POWERED SUBWOOFER SYSTEM
11
12
BASS LEVEL
POWER
MIN MAX
15
SUB1
SUB1
POWERED SUBWOOFER SYSTEM
SUB1
POWERED SUBWOOFER SYSTEM
SUB1
POWERED SUBWOOFER SYSTEM
16
SUB1
POWERED SUBWOOFER SYSTEM
14
11