Danby Designer DBC117A2BSSDD-RF Manual Del Propietário página 5

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging in to
avoid damage to internal components.
1. Remove the hinge cover and hinge from the right
side of the cabinet. Remove the hole covers from
the screw holes on the left side of the cabinet.
Remove the door from the cabinet.
2. Install the hole covers in the screw holes on the
right side of the cabinet. Move the hole cover
on the top of the door from the left to the right
side to expose the hinge pin hole on the left side
of the door. Remove the screws from the door
handle and move the door handle to the right
side of the door. Pre-drilled screw holes can be
found on the right side of the door.
3. Remove the adjustable foot from the bottom left
side of the cabinet. Remove the solid foot and
the lower hinge from the bottom right side of the
cabinet. Install the adjustable foot on the bottom
right side of the cabinet. Install the solid foot and
the lower hinge on the bottom left side of the
cabinet.
4. Install the door on the cabinet. Install the upper
hinge and the hinge cover on the top left side of
the cabinet. When reinstalling the door, ensure
that the top of the door is level with the top of
the cabinet and that the rubber gasket makes a
good seal with the cabinet all the way around.
1
2
3
4
4