Nostalgia Products Thermostar TSWCBLICDS35BK Instrucciones Y Recetas página 10

4. Press the power button again to shut off the power. This will stop ice and cold water making.
DISPENSING COLD WATER
Once the machine has been powered on, the Cold Water Indicator
light will flash, indicating that water is being cooled.
It will take up to 2 hours to get the water to it temperature set point. When it reaches
the temperature set point, the Cold Water Indicator light will remain on.
1. Place bottle, glass, or pitcher below the Ice/Water Spout.
2. Press and release the Dispense Water button to start dispensing
water. The button backlight will light up while dispensing.
3. Press the Dispense Water button again to stop dispensing. NOTE: The machine will stop
dispensing automatically after 1 minute if not stopped manually.
DISPENSING ICE
Press the Make Ice button and the machine will begin ice making production, filling
the internal ice storage. At this time, the Ice Indicator light will begin flashing.
When the Ice Indicator light stops flashing and remains on, the ice making cycle
has completed. Ice making will suspended, and you can now dispense ice.
1. Place bottle, glass, or pitcher below the Ice/Water Spout.
2. Press and release the Dispense Ice button to dispense ice automatically.
The button backlight will light up while dispensing.
3. Press the Dispense Ice button again to stop dispensing.
NOTE: The machine will stop dispensing automatically
after 10 seconds if not stopped manually.
NOTE: After ice is full, the machine will stop making ice and start making cold water.
After ice is dispensed, the machine will start making ice again.
REPLACING AN EMPTY BOTTLE/LOW WATER INDICATOR LIGHTS
Replace the bottle as soon as you notice that it is empty. The Add Water
indicator light will tell turn on to tell you that a new bottle is needed. Follow
steps in "WATER JUG INSTALLATION" when adding a new water jug.
HELPFUL TIPS
DISPENSER IS NOT WORKING
• Make sure that the power cord is properly connected to a working outlet.
• Replace water bottle if Add Water Indicator light is on.
WATER IS LEAKING
• The most common cause of leaks is a cracked bottle. Replace
old water bottle with a new water bottle.
NO WATER IS COMING OUT
• Make sure bottle is not empty. If so, replace it.
• Make sure that you fully press the water control buttons.
WATER DISPENSER IS NOT COLD
• If not making ice, it may take up to 1 hour to cool. If making ice while
cooling water, it may take up to 3 hours to cool water.
8